Page 5 of 5

Re: doublespace unable to save in WIM

PostPosted: Mon May 04, 2015 11:35 am
by admin
The new PE is ready and has been uploaded to:

www.zipmagic.co/pebuild.7zip

Please copy this to a FAT32 formatted USB drive and this should let you boot, and collect the raw data that we need.

Please let me know if there's any problems.

Thank you :)

Re: doublespace unable to save in WIM

PostPosted: Mon May 04, 2015 5:50 pm
by grigoris_a

Re: doublespace unable to save in WIM

PostPosted: Mon May 04, 2015 6:00 pm
by admin
Excellent - and thank you very much!

We're now investigating.

Re: doublespace unable to save in WIM

PostPosted: Mon May 04, 2015 6:03 pm
by grigoris_a
I believe I can restore now

Re: doublespace unable to save in WIM

PostPosted: Mon May 04, 2015 7:12 pm
by admin
Yes thanks very much for your patience. If we need more help I'll be sure to let you know!

Re: doublespace unable to save in WIM

PostPosted: Mon May 04, 2015 10:18 pm
by admin
OK, on this tablet, how many times did you compress and/or recompress the disk, of course not counting the times that were done before you imaged/reimaged the system using external cloning tools?

I understand that it appears like there were at least three compression operations:

"In fact, since WOF assigns data source IDs sequentially starting at 0, there must have been at least 3 separate extraction operations done on this volume without re-formatting."


However, if I understood your earlier reports correctly, you did one compression operation (referred to as an extraction operation above, because the compressed image is extracted after being created onto the target partition in WIMBoot mode), and then immediately ran into the issue during your second compression operation?

Please let us know if this understanding is correct or mistaken. This way we'll be able to refine our research some more.

Re: doublespace unable to save in WIM

PostPosted: Mon May 11, 2015 5:49 am
by grigoris_a
Sorry for late reply but I saw your post today.I think it was only one compression and the other attempts failed.I dont remember for sure though.

Re: [Solved] doublespace unable to save in WIM

PostPosted: Fri May 29, 2015 5:40 pm
by admin
Please be advised that this issue has been solved in the latest ZIPmagic version 12.8.8 and you should never run into this issue again.

Thanks very much for reporting it and helping us solve it for all users!